Norman Logo
Link to Home Link to Products Link to Applications Link to Support Link to About Norman Link to Newsroom Link to Info Request Link to Catalog Link to Dealers Link to Contact
  Series 500
  Power Supplies
P808m Power Supply
The P808m (810665) Power Supply was built for high volume photography, and it is a popular choice for undergraduate and other similar applications. It incorporates four independently controlled lampheads that can be set to full, half, quarter power or off, equaling 200, 100 and 50-watt-second settings. Channel power can also be combined to use 400 w-s on one or two lampheads, and even 800 w-s is possible when using a single LH500+ Lamphead.

A three-position modeling lamp switch allows the lamps to ratio with the power level, remain full or be switched off completely. The fail-to-flash alarm system provides an audible signal in the event of a lamphead misfire.

P808m (810665)

P808m/TLC Power Supply
The P808m/TLC (810668) has the same great features as the P808m, along with a switch guard feature that prevents settings from being accidentally changed during travel or set-up.

It is also important in school photography to properly expose each subject without altering the background exposure. The Tone Light Control (TLC) feature uses a small controller attached to the camera, which will allow subject lighting only to be set to any one of three levels on a per-subject basis. The P808m/TLC can be ordered with a factory set TLC mode to control the fill light, or the main and fill in either two or three output levels.

P808m/TLC (810668)

TLC10 Controller
The TLC10 (810683) Controller can be mounted in a convenient place on or near the camera using Velcro™. A supplied 8' phone cord connects it to the power pack, and another cable is connected to the camera sync. A home-base switch on the power supply allows the TLC to automatically return to that setting after each exposure.

TLC10 (810683)

Specifications   P808m & P808m/TLC 
Power 800 watt-seconds
Lamp Outlets 4
Channels 4
Single Lamphead Power Options 50 to 800 w-s
Full Power Recycle Time 2 seconds
Sync Trigger 1/4" sync jack
Sync Voltage 15 VDC
Lamphead Compatibility Series 500
Modeling Lamp Control Ratio, full & off
Supply Voltage 105-125 VAC, 60 HZ
Circuit Breaker 15A at 115 VAC
Dimensions (height, width, length) 7" x 6.44" x 8.63"
Weight 9.7 pounds